Aim Robotics FD400 Fluid Dispenser
The Aim Robotics FD400 Fluid Dispenser is Plug&Dispense. Easy-to-use and all-electric, the FD400 brings easy fluid dispensing to collaborative robots. With just a single point of contact with the robot (an M8 conenction) and no need for compressed air, the FD400 makes dispensing easy, predictable, and accurate. Thanks to its URCap, clear interface, and intuitive software, this UR Certified dispenser from Aim Robotics will revolutionize the way you dispense!
5.650,00€ excl. VAT
The Aim Robotics FD400 Fluid Dispenser is a Plug&Dispense solution. It is a modern, electric fluid dispensing tool designed to be mounted on a collaborative robot. Fluid dispensing can be a messy and complicated task, but with the FD400 it is not only achievable, but even easy. The Aim Robotics FD400 works with any cobot from Universal Robots and can be easily set up and programmed through its URCap. Dispensing is controlled, accurate, and reliable thanks to Aim Robotics’ single screw pump dispensing design.
The tool does away with compressed air in favor of electricity. This means that a single M8 connection is all that is necessary to control and power the gripper, simplifying maintenance and reducing points of failure. Designed for use with 400ML (DIN1284) cartridges, the FD400 can also accept 310ML cartridges with an adaptor.
How it works
The FD400 uses a single screw pump dispensing system; fluid is pumped through the system with an electrical motor removing the use of compressed air. The Aim Robotics URCap guides the user in setup and is easily reprogrammed. Further, the FD400’s cleaning cycles help to prevent fluid build up in the nozzle. From within the Aim URCap you can control the dispensing speed.
Exchangeable Auger Screws
3 different auger screw sizes make FD Series dispensers the perfect fit for most dispensing applications:
- 5mm pitch – used when either additional inherent flow resistance is required and/or a finer deposit rate control is required. Lowest flow rate.
- 7.5mm pitch – appropriate for most applications. Inherent resistance and material flow are moderate.
- 10mm pitch – used when high flow rates and low resistance to flow are required.
Number of gripping elements
Find suitable products now